Page 1 of 1

MPLAB V 6.31

PostPosted: Tue Jul 20, 2004 2:52 am
by shwesap

We have installed MPLAB IDE V 6.31

Is there not an Edit Proj option in this version.

would be really helpful if u cld tell us where we cld find the document...

Building A Salvo Application with hi-tech picc and Microchip mplab v 6.31


Re: MPLAB V 6.31

PostPosted: Tue Jul 20, 2004 7:58 am
by aek
PLEASE use "Post Reply" instead of continually starting a new topic. All of this thread should have been in a single thread!

------------------


Re: MPLAB V 6.31

PostPosted: Tue Jul 20, 2004 8:02 am
by aek
OK, at this point, I suspect you have a bad install of PICC + MPLAB.

You need to upgrade to MPLAB v6.41 or later, install MPLAB, then (re-)install PICC, then install the MPLAB PICC plug-in/DLL available at http://www.htsoft.com/updates/mplab/mplab6/update.php.

You should then be able to immediately build the projects provided in the Salvo distribution.

Explicit intructions on building with MPLAB v6.x are found here:http://www.pumpkininc.com/content/doc/appnote/an-26.pdf.

Finally, since it appears that you purchased HI-TECH Salvo, you'll need to direct further support enquiries to them. http://www.htsoft.com

------------------


Re: MPLAB V 6.31

PostPosted: Wed Jul 21, 2004 11:36 am
by shwesap

Following instructions as in AN-26
Have downloaded MPlab IDE 6.31
HT-picc 8.02

As mentioned in AN 26 <pic.h > needs to be included...but the main.c does not allow me to make changes as it is a read only file..
the error without including it is as follows

Executing: C:HT_PICBINPICC.EXE -Q -MPLAB -C -EMEM.CCE -16F877 MEM.C -Omem.obj -Ic:SALVOINC -G
Error[000] : Can't open chip info file C:HT-PICLIBpicinfo.ini
Halting build on first failure as requested.
BUILD FAILED: Wed Jul 21 12:58:55 2004

thankx for the immediate reply,