Page 1 of 1

USART help please

PostPosted: Tue Jul 18, 2006 5:24 am
by fil323
I’m trying to have a communication between two computers and they’re both connected via a RS232...like I would type in a certain char and it would be outputed on other side...

I’m quite a newb in using USART and was hoping for some help...am using a commonly used device produced by MAXIM and is called the MAX232 and using PIC18F458.

I looked at a few earlier posts but are a little outdated...any help would be appreciated.


Re: USART help please

PostPosted: Tue Jul 18, 2006 6:28 am
by aek
The best place for answers to these PIC-specific questions (that aren't Salvo related) is in Microchip's forums ..

------------------


Re: USART help please

PostPosted: Tue Jul 18, 2006 6:51 am
by fil323
my bad.