Page 1 of 1


PostPosted: Thu Apr 09, 2009 4:58 am
by BlackKnight
I am trying to connect a camera to UART1 and take pictures with it. I have working python code that uses ser.write() and in order to send and recieve commands to the camera. I am now trying to translate this code to salvo, using the CSK_UART library, but I am a little confused as to how this thing actually reads and writes. I've been messing around with CSK_PutcharTx1, CSK_RcvcharRx1, CSK_GetRx1Buff, and CSK_SendcharTx1, but I can't seem to get it right. If anybody has some examples of reading and writing to and from the UART or can offer any other help I'd appreciate it. Thanks.

Re: UART Help

PostPosted: Thu Apr 09, 2009 5:51 am
by aek
CubeSat Kit customers can see a full example in the test1 CubeSat kit example application.

There is a newer and nicer set of similar functions here:

These are freeware and available to all. However, these are just code, with no examples.