Page 1 of 1

Using SiLabs USB Debug Adapter

PostPosted: Thu Apr 17, 2014 7:55 am
by sncuser
Can I use this debug adapter with the PPM B1? How do I determine the JTAG device chain parameters?

Thanks!

Re: Using SiLabs USB Debug Adapter

PostPosted: Thu Apr 17, 2014 9:28 am
by aek
Dunno what
JTAG device chain parameters
means, but we provide these debug adapters for use with Keil's Cx51 toolset.

Follow the Keil instructions on how to use that debug adapter. You will likely have to add Silicon Devices' driver so that uVision is happy and can see it.

Note that there are two FPC connectors on the underside of PPM B1. One is for the USB debug adapter via Pumpkin's JFPC-8051, the other is a debug connector not normally used.